Evidence: verified

Anker SOLIX C1000

A specification-based US-variant profile with an editable runtime model. Not a hands-on review or measured performance test.

Data verified: 2026-09-22 · Market: US · Generation: A1761

Capacity1,056 Wh
AC output1,800 W
Weight28.4 lb

What this profile can tell you

The capacity and output figures below come from the cited manufacturer material for the US model. Use them to test a specific load, compare size and weight, and identify specifications that still need confirmation. Calculated runtime is an estimate built from the assumptions you choose; it is not a measured claim about this unit.

US model specifications

Nominal capacity1,056 Wh
Continuous AC output1,800 W
AC voltage/frequency120 V, 50/60 Hz
SurgeUnknown
Marketing boost modeSurgePad up to 2400 W; not treated as a surge rating
Chemistry / cycle claimLiFePO4; cycle claim not established
Weight12.9 kg / 28.4 lb
Dimensions376 × 205 × 265 mm
Maximum AC charging input1,300 W
Solar input600 W maximum; voltage/current details unknown
WarrantyNot established from the cited source

Planning scenarios

These are calculated illustrations, not tests. Each assumes a new-capacity factor, a full starting charge, a 10% stopping reserve, 85% AC conversion efficiency, and 5 W of inverter idle draw. Replace them with your own settings in the runtime tool below.

Sustained AC loadBattery-side demandEstimated runtimeOutput check
50 W63.8 W14.9 hoursBelow documented 1,800 W continuous limit
100 W122.6 W7.7 hoursBelow documented 1,800 W continuous limit
300 W357.9 W2.7 hoursBelow documented 1,800 W continuous limit

A capacity-based runtime does not establish startup compatibility. The table also does not model charging while in use, temperature, battery management limits, or changing device loads.

Planning runtime

The station capacity and documented continuous output below are product facts. Efficiency, reserve, idle draw, and health remain editable planning assumptions, not measured model performance.

Runtime with Anker SOLIX C1000

Illustrative inputs — replace with your measurements.

Estimated runtime

Enter your sustained average load and calculate.

Tradeoffs and unresolved checks

  • SurgePad is a marketing operating mode and is not used as ordinary surge compatibility evidence.
  • USB/DC compatibility requires matching individual and shared port limits, voltage profiles, protocols, and cables.
  • Solar input wattage alone does not establish voltage, current, polarity, or connector compatibility.
  • Calculated runtime is not measured runtime and may differ with load, temperature, unit condition, and firmware behavior.

Manufacturer and evidence

Capacity evidence
Introduction to Anker SOLIX C1000
Output evidence
Introduction to Anker SOLIX C1000
Physical evidence
Introduction to Anker SOLIX C1000
Charging evidence
Introduction to Anker SOLIX C1000
Warranty evidence
Not established from the cited sources

This page uses an ordinary manufacturer link.

View manufacturer page